Rear gear ratio from trap speed calculator

Rear axle ratio that puts the engine at your target RPM at the 1/4 mile trap speed.

Advanced options
Advertisement

About this tool

Find the rear axle ratio that puts your engine at its target RPM at the 1/4 mile trap speed.

Advertisement

Frequently asked questions

How do I pick a rear gear from trap speed?

Decide the RPM you want at the finish line, usually near your power peak or shift point, then enter your trap speed, tire diameter and the gear you are in at the end. The calculator gives the ratio that lands on that RPM.

Which transmission gear do I use?

Use the gear you are in as you cross the finish line. Enter 1 for a direct-drive gear, or the actual ratio, such as 0.75, for an overdrive gear.

Which tire diameter should I enter?

Use the rolling diameter of the tire at speed. Slicks grow noticeably at high speed, so a measured or rolled-out figure beats the printed size.

What if I only see the trap speed on a 1/8 mile?

Use the speed you would trap on the quarter mile, or the 1/8 mile speed if that is the finish you are gearing for. Enter the RPM you want at that point.

More in Drag Racing Gearing & Drivetrain Calculators: Starting Line Ratio, Converter Stall & Slip, Rear Gear From Trap Speed, Gear Ratio Change, RPM Drop Between Gears, Tire Rollout & Drivetrain Loss

Other calculators

Advertisement
Advertisement