Horsepower calculator from 1/4 mile time
Work backward from a 1/4 mile result to estimate engine and wheel horsepower.
About this tool
Work backward from a quarter-mile time or trap speed to estimate the engine and wheel horsepower the car is making.
Estimating horsepower from a time slip
If you know a car's weight and its quarter-mile ET or trap speed, you can solve the standard formulas backwards to estimate engine power: hp = weight ÷ (ET ÷ 5.825)³ or hp = weight × (trap ÷ 234)³. The calculator also shows wheel horsepower after a drivetrain loss.
Trap speed is the better input. Elapsed time is strongly affected by traction and the launch, while trap speed is dominated by power and weight.
Worked example
A 3,500 lb car runs 12.0 seconds in the quarter mile.
- ET method: 3,500 ÷ (12.0 ÷ 5.825)³ = about 400 hp at the crank.
- If the same car trapped at 118 mph, the speed method gives 3,500 × (118 ÷ 234)³ = about 449 hp.
A trap speed estimate higher than the ET estimate means the car is losing time in the first 60 feet. Fixing the launch could pick up the difference.
Crank vs wheel horsepower
Engine (crank) horsepower is measured before the transmission and drivetrain. Wheel horsepower (whp) is measured on a chassis dyno after those losses. Typical losses are around 10-15% for manual rear-wheel-drive cars, 15-20% for automatics, and 20-25% for all-wheel drive, though actual values vary. Choose the loss that matches your drivetrain, or leave the default as a starting point.
Frequently asked questions
Is trap speed or elapsed time better for estimating power?
Trap speed is the better indicator, because it depends mostly on power and weight and less on launch.
What is drivetrain loss?
Power lost in the transmission, driveshaft and differential. About 12–15% for manuals and 15–20% for automatics is typical.
Is estimating horsepower from ET accurate?
It gives a reasonable ballpark if the car launched cleanly. Because traction and shifting affect ET, treat the number as a minimum. Trap speed estimates are generally more reliable.
Which is better to use, ET or trap speed?
Use trap speed when you have it. It measures the car near the end of the run and depends mostly on power and weight.
What drivetrain loss should I use?
Around 12-15% for manual rear-wheel-drive, 15-18% for automatic and about 20-25% for AWD are common assumptions. A dyno comparison is the best way to find your car's actual figure.
How much does weight matter?
A lot. The result scales with weight: reducing a car by 100 lb is worth roughly the same as adding about 3% power in a quarter-mile run.