1/4 mile calculator: ET and trap speed estimator
Estimate elapsed time and trap speed from power and weight. Assumes good traction and a well-driven pass.
About this tool
Estimate quarter-mile elapsed time and trap speed from horsepower and vehicle weight.
How the quarter-mile estimate works
The calculator uses the widely used power-to-weight formulas: ET = 5.825 × (weight ÷ horsepower)^⅓ and trap speed = 234 × (horsepower ÷ weight)^⅓. Weight is the car with driver, in pounds, and horsepower is the power at the crank.
These equations describe a well-driven pass with good traction and typical gearing. They are estimates, not predictions, and they work best for rear-wheel-drive cars with sticky tires.
Worked example: 400 hp and 3,500 lb
The power-to-weight ratio is 3,500 ÷ 400 = 8.75 lb per horsepower. Taking the cube root gives 2.061, so:
- ET: 5.825 × 2.061 = 12.0 seconds
- Trap speed: 234 × 0.4854 = 113.6 mph
If your real car runs 12.8 seconds at 110 mph, the trap speed suggests the engine is producing close to the claimed power and the slower time is coming from traction or the launch.
Why trap speed tells you more than ET
Elapsed time depends heavily on the first 60 feet: tire grip, launch RPM and shifting. Trap speed is measured near the end of the run and reflects mostly horsepower and weight. If your ET is worse than the estimate but your trap speed matches, you have power to spare and the improvement is in the launch, tires or gearing.
Use the horsepower estimator to work backwards from your time slip.
Frequently asked questions
How accurate is a quarter-mile estimate?
Within roughly a few tenths for a well-driven pass with good traction. Launch, tires, gearing and weather all change the real result.
Which horsepower should I enter?
Use flywheel horsepower with weight including the driver. Wheel horsepower is typically 10–20% lower.
How accurate is a quarter-mile estimate?
With good traction the formula is typically within a few tenths of a second. Traction, launch, gearing, density altitude, tires and drivetrain losses all cause real passes to differ.
What weight should I use?
Use the weight of the car as it runs, including the driver and fuel, since that is what the track scale will read.
Should I use crank or wheel horsepower?
The formula expects crank (engine) horsepower. If you only know wheel horsepower from a dyno, divide by about 0.85 for a manual or 0.82 for an automatic to estimate crank power.
How do weather and altitude affect my time?
Hot, humid air and high altitude reduce engine power. Use the density altitude calculator to see how much, and the dyno correction tool to compare runs fairly.
What is a good quarter-mile time?
Most stock cars run 14 to 17 seconds. 13 seconds is quick, 12 seconds is fast, and 10 seconds or less requires a purpose-built car and a roll cage.