Advertisement

Wheel lug nut torque chart (OEM specs)

Factory wheel nut torque taken from manufacturer owner’s manuals and service documents, for the model year shown. Filter by make or type a model.

VehicleYearsft-lbNmThreadNotes

Always confirm in your owner’s manual or door-jamb label. Every value here was read from the manufacturer’s own document for the year shown in the Years column. Torque can change between model years, trims, wheel types and axles, so use the number for your exact vehicle. Aftermarket wheels follow the wheel maker’s spec. Tighten in a star pattern in two or three passes with a calibrated torque wrench (not an impact gun), keep threads clean and dry, and re-check torque after 25 to 100 miles. Thread size is shown only where the manual states it.

About this tool

Factory wheel lug nut torque taken from manufacturer owner's manuals, with the model year each value comes from. Search by make or model.

Why lug nut torque matters

Wheel studs and lug nuts work by clamping the wheel against the hub. Too little torque can let the wheel loosen and come off. Too much torque can stretch the studs, warp brake rotors or crack the wheel. The correct value is set by the vehicle maker and depends on the stud size and thread.

How to tighten wheels correctly

  1. Clean the threads and mating surfaces. Do not oil or grease the studs unless the manufacturer says to.
  2. Thread each nut on by hand to avoid cross-threading.
  3. Snug all nuts in a star (criss-cross) pattern with the wheel on the ground or the car lightly lowered.
  4. Finish with a calibrated torque wrench to the specified value, again in a star pattern.
  5. Recheck the torque after 50 to 100 miles, particularly after fitting new or refinished wheels.

Typical torque ranges

In the owner's manuals behind this chart, most Toyota, Honda, Nissan, Subaru and Hyundai cars and crossovers call for roughly 76-94 ft-lb. Full-size pickups and SUVs from Ford, Ram and Jeep are higher, at about 130-165 ft-lb. These ranges are only general guidance. Always use the value in your owner's manual or the chart on this page for your specific vehicle, and check aftermarket wheel makers' instructions as they may differ.

Advertisement

Frequently asked questions

Why does lug nut torque matter?

Too loose and a wheel can come off; too tight can stretch studs and warp rotors. Use a torque wrench in a star pattern.

Should I re-torque after driving?

Yes. Recheck after 50–100 miles, especially on alloy wheels.

What happens if lug nuts are over-tightened?

It can stretch or snap studs, warp the brake rotors and make the nuts hard to remove. Over-tightening with an impact wrench is a common cause.

Should I use an impact wrench on lug nuts?

An impact wrench is fine for removal and for running nuts down, but finish with a torque wrench. Torque sticks help but a calibrated wrench is more accurate.

Do I need to re-torque lug nuts after changing a tire?

Yes. Check them after 50 to 100 miles because the nuts can settle as the wheel seats against the hub.

Should lug nuts be lubricated?

Specs assume clean, dry threads. Lubricant changes the clamping force for a given torque, so only use it if the manufacturer says so.

What is the tightening sequence?

Tighten in a star or criss-cross pattern so the wheel seats evenly against the hub. Never tighten adjacent nuts one after the other.

More in Lug Nut Torque, Bolt Pattern & Tire Pressure Charts

Other calculators

Advertisement