Advertisement

Camshaft calculator: cam spec builder

Estimated cam specs from your engine, how you use it and your power goals.

About this tool

Estimate cam specs from engine type, usage and power goals, with rocker ratio support.

Advertisement

Frequently asked questions

What is duration?

Degrees of crank rotation the valve is open; longer favors high RPM.

Does Ti-VCT change the recommendation?

Yes. With Ti-VCT selected the builder uses a tighter LSA, figures idle speed and vacuum from the phased overlap, and adds PCM tuning and piston-to-valve notes.

What cylinder head flow does the builder recommend?

It estimates intake and exhaust flow per cylinder at 28 inches of water from your power goal, plus a valve size, intake port volume and port cross-section area for your peak RPM. Compare these with a head maker's flow sheet.

Which valve sizes are OEM?

OEM valve sizes are shown for engines where a size is known. Ford Coyote Gen 1 to 3 sizes are from Ford Performance; the LS3/L92 size matches the OEM replacement valve sets. Others are commonly cited sizes and flagged to check against your heads. Engines marked as varying by casting show no figure.

Will the recommended valves fit my engine?

Enter your bore. The builder checks the intake and exhaust valve sizes against it and, if they do not fit, shows the minimum bore needed and the largest valve and flow your bore allows.

How is intake runner length chosen?

The builder sizes it from when your cam closes the intake valve and the RPM you want peak torque at, using intake pressure-wave tuning. Longer runners favor low-RPM torque and shorter ones favor top-end power. With boost the length matters much less.

What is LSA?

Lobe separation angle; tighter gives more mid-range but a lumpier idle.

More in Camshaft, Rocker Arm & Valve Spring Calculators

Other calculators

Advertisement