Gear ratio and engine RPM calculator
Engine RPM at a given speed from tire size, axle ratio and transmission gear.
About this tool
Calculate engine RPM at any speed from tire size, axle ratio and transmission gear.
How engine RPM is calculated
Engine speed depends on road speed, tire diameter, the transmission gear and the axle (final drive) ratio. The formula is:
RPM = speed (mph) × 1056 ÷ (π × tire diameter in inches) × axle ratio × gear ratio
The calculator also applies a small 1% correction because a loaded tire is slightly smaller than its free diameter. Use 1.00 as the transmission ratio for a direct-drive gear. For an overdrive gear use the ratio from the transmission spec, such as 0.74.
Worked example: 265/70R17 with 3.73 gears
A 265/70R17 tire is about 31.6 inches tall. With a 3.73 axle ratio, the engine turns:
| Gear | Ratio | RPM at 65 mph |
|---|---|---|
| Direct drive | 1.00 | 2,605 |
| Overdrive | 0.74 | 1,927 |
Changing to a 3.42 axle ratio in the same overdrive gear drops that to about 1,767 RPM. That is roughly 8% lower, which usually means a little better highway fuel economy but less pulling power when towing or climbing.
Choosing a gear ratio
- Numerically higher ratios (3.73, 4.10, 4.56) accelerate harder and tow better but turn the engine faster at highway speed.
- Numerically lower ratios (2.73, 3.08, 3.42) are calmer and more economical on the highway but feel slower off the line.
- Bigger tires act like a taller (lower numerical) gear. Fitting 33-inch tires to a truck is often paired with a regear to restore performance.
- For drag racing, pick the ratio that puts the engine near its power peak at the finish line in your final gear.
Frequently asked questions
How do I calculate RPM from speed?
RPM = (mph × gear ratio × axle ratio × 336) ÷ tire diameter in inches.
What axle ratio suits towing?
Numerically higher ratios (3.73–4.10) give more pulling power at the cost of highway economy.
What RPM should my engine run at 70 mph?
It depends on the vehicle, but many modern cars cruise between roughly 1,500 and 2,500 RPM at 70 mph in top gear. Check the calculator for your gear, axle and tire combination.
How do I find my axle ratio?
Look for a tag on the differential cover or a code on the build sheet or door jamb sticker. You can also lift the rear wheels, turn both wheels together one full turn and count the driveshaft rotations: the count is the ratio.
Does a larger tire change my effective gear ratio?
Yes. A taller tire covers more ground per revolution, so it behaves like a numerically lower gear. A 3.73 ratio with much taller tires may feel closer to a 3.42 ratio.
What is the effect of going from 3.55 to 4.10 gears?
The ratio change is about 15.5% (4.10 ÷ 3.55). The engine runs about 15.5% faster at any speed, which improves acceleration and towing but raises cruising RPM by the same amount.
Why is the answer slightly different from my tachometer?
The calculator assumes no tire slip and a small deflection correction. Real tires wear, vary in pressure and differ from the nominal size, so a few percent of difference is normal.