Turbo boost and airflow calculator
Pressure ratio, estimated power and engine airflow.
About this tool
Pressure ratio, estimated power and engine airflow from boost.
How the pressure ratio works
Pressure ratio compares the air pressure after the compressor with the pressure before it: PR = (boost + ambient) ÷ ambient. At sea level, ambient is about 14.7 psi, so 10 psi of boost gives a ratio of about 1.68. Higher ratios pack more air into the engine, which is what makes extra power.
The calculator estimates power as naturally aspirated hp × pressure ratio × intercooler factor and airflow as about 0.11 lb/min per horsepower. These are rough planning numbers, not a substitute for a compressor map.
Worked example: 300 hp engine at 10 psi
| Step | Result |
|---|---|
| Pressure ratio (10 + 14.7) ÷ 14.7 | 1.68 : 1 |
| Estimated power (300 × 1.68, perfect intercooling) | about 504 hp |
| Airflow (504 × 0.11) | about 55 lb/min |
A real intercooler is less than perfect and heat soak lowers the figure, so expect somewhat less. Pick a turbo whose map shows that airflow in an efficient island at that pressure ratio.
Things that limit boost
- Fuel: injectors and the fuel pump must keep up, or the engine runs lean.
- Octane: higher boost needs higher octane or E85 to avoid knock.
- Compression ratio: lower static compression tolerates more boost.
- Altitude: thinner air raises the pressure ratio needed for the same power.
Frequently asked questions
How is pressure ratio computed?
(boost + atmospheric pressure) ÷ atmospheric pressure.
Why does airflow matter?
It determines which compressor can supply the engine.
Is more boost always more power?
Only up to a point. Past the efficient range of the compressor the air gets very hot, and knock or heat limit the power.
Why does altitude change the numbers?
Ambient pressure drops, so the same gauge boost gives a higher pressure ratio but the engine still ingests less mass of air.
Do I need an intercooler?
For anything more than mild boost, yes. Cooler air is denser and less prone to knock.
Can I trust the airflow number to pick a turbo?
Treat it as a starting point and then check the exact compressor map from the turbo maker.