Engine compression ratio calculator
Static compression ratio from bore, stroke and combustion chamber volumes.
About this tool
Static compression ratio from bore, stroke, chamber volume, head gasket and piston dish or dome.
What static compression ratio means
Static compression ratio is the volume in the cylinder with the piston at the bottom of its stroke divided by the volume with the piston at the top: CR = (swept volume + clearance volume) ÷ clearance volume.
The clearance volume is everything left above the piston at top dead centre: the head chamber, the head gasket, any piston dish or dome and the gap between the piston and the block deck.
Worked example using the default values
For an 86 × 86 mm cylinder, a 45 cc chamber, a 1.2 mm gasket with 87 mm bore, a 6 cc dish and 0.2 mm piston-to-deck clearance:
- Swept volume = π/4 × 86² × 86 ÷ 1000 = 499.6 cc
- Clearance volume = 45 + 7.1 (gasket) + 6 (dish) + 1.2 (deck) = 59.3 cc
- CR = (499.6 + 59.3) ÷ 59.3 = 9.42 : 1
Choosing a compression ratio
- Naturally aspirated street engines on pump fuel commonly run 9.5-11.5:1, depending on the head design, cam and octane.
- Forced induction (turbo or supercharger) engines are usually built lower, around 8-9.5:1, because boost raises the effective pressure.
- Larger cams bleed off pressure at low RPM, so engines with long-duration cams tolerate a higher static ratio.
- Always match the ratio to the fuel octane. Higher compression needs more octane or knock will damage the engine.
Frequently asked questions
What compression ratio is safe on pump gas?
About 9–11:1 for naturally aspirated engines; boosted engines generally run lower.
What is dynamic compression?
The effective ratio after the intake valve closes. It depends on cam timing and is lower than static.
What is a good compression ratio for pump gas?
Many street engines with iron heads run 9.0-10.0:1 and modern aluminium-head engines often run 10.5-11.5:1 on premium gas. The right figure depends on combustion chamber design, cam timing, cooling and fuel quality.
How does a thicker head gasket change compression?
A thicker gasket adds clearance volume, which lowers the ratio. A thinner gasket or milling the heads raises it. The calculator shows the effect of changing gasket thickness.
What is dynamic compression ratio?
It accounts for the intake valve closing late, so part of the stroke does not compress the air. It is more closely related to detonation resistance than the static ratio, which is what this calculator gives.
What does piston dish do?
A dished piston adds clearance volume and lowers compression. A domed piston subtracts volume and raises it. Enter dome volume as a negative number.
How do I measure chamber volume?
Seal the spark plug and valves with a plate, then fill the chamber with fluid from a burette and record how many cc it takes. This is called cc'ing the heads.