Engine displacement calculator
Displacement from bore, stroke and number of cylinders.
About this tool
Engine displacement from bore, stroke and number of cylinders.
How displacement is calculated
Engine displacement is the total swept volume of all cylinders: displacement = π/4 × bore² × stroke × number of cylinders. With the bore and stroke in millimetres, divide by 1000 to get cubic centimetres. Divide by 16.387 to convert cubic centimetres to cubic inches.
Worked examples
| Engine | Bore × stroke | Displacement |
|---|---|---|
| 4-cylinder | 86 × 86 mm | 1,998 cc (2.0 L, 122 cu in) |
| V8 (Hemi 5.7 L) | 3.917 × 3.578 in | about 345 cu in (5.7 L) |
| GM 6.0 L V8 | 4.000 × 3.622 in | about 364 cu in (6.0 L) |
A 0.030 inch overbore on a 350 cubic inch small-block V8 adds about 5 cubic inches. A longer stroke from a stroker crank increases displacement without changing the bore.
Why displacement matters
Displacement sets how much air an engine can move per cycle, so it is a primary factor in power and torque potential. It also affects fuel economy, insurance, taxes and racing class eligibility in many countries. The calculator gives cc, litres and cubic inches so you can compare engines quoted in different units.
Frequently asked questions
How is displacement calculated?
π/4 × bore² × stroke × cylinders.
How do I convert cubic inches to litres?
Multiply by 0.016387.
How do I calculate engine displacement?
Multiply π/4 by the bore squared, the stroke and the number of cylinders. In millimetres, divide the result by 1000 to get cc.
How many cc is one litre?
One litre is 1,000 cc. An engine of 1,998 cc is marketed as a 2.0 L.
How do I convert cubic inches to litres?
Multiply cubic inches by 0.016387. A 350 cubic inch engine is 5.7 L.
Does overboring increase displacement?
Yes. A larger bore increases the swept volume of each cylinder. Check the cylinder wall thickness and head gasket bore before overboring.
What is a stroker engine?
A stroker uses a crankshaft with a longer stroke, which raises displacement without enlarging the bore. It increases low-end torque but changes piston speed and rod angle.